Music on Hold and PARNUM=154.

[antek]

Hello,
I am asking You for subject which I can not solve because
I haven't hardware in my lab-room to test it and customer
is waiting ).

MD110 (CADAP ---> VERSION=LZY2035151/4/R3A), BC10 with LPU5,
IPU and HDU5, 1 x LIM, 3 x magazines.

From beginning PARNUM=154 was set up to PARVAL=0 - no MoH.
Then customer bought music source and I was going to change
this value to PARVAL=1 to use MoH from Discman connected to TMU.

In documentation I have read that TMU cards should be remove
an reinsert.

I made:
- uninstall 3 x TMU - one in each magazine,
- reinsert TMU in lowest LIM position in another slot,
- install all 3 x TMU card.

I can not set up PARNUM=154 to PARVAL=1.

What does it mean ?
Help me!

Antek

 

[patcher]

You had to do it during no traffic hours. CNBOE all TMUs, then changes parnum 154 to 2 not 1. This case you will not change it again next time if you need 2 MOH inputs. After CNBOE then change the parval to 2 then CNHUI:BPOS=... starting on the lower magazine. /patcher