Hi all,
I am attempting to do a move in ld 20, but when I attempt to move the TN to a free TN (which I found by doing a luvu), I receive the error "SCH1509". I've never seen this before.
Any thoughts?
Thanks!
This usually means that CCM or Symposium has the set acquired. Go to the app that has it acquired, un-acquire the tn before making changes. You will also have to update the CCM with the new tn as well.
Well, it looks like CCM is the culprit. It scared me, so I reverted back to trying to physically swap the lines, only to learn the riser that says "Jacks" actually refers to another riser/patch panel (I did not know existed) rather than the desk jacks themselves.
Thanks all
If you need to move an ACD seat, either move it by re-terminating the cabling/jumpers in the wiring closet or IDF. THe other option is to completely out the seat, out the set built on the TN and then rebuild it from scratch on a new TN.
Moving a TN associated with ACD in programming can lead to data corruption.
I agree, never use the mov command on an ACD set. His question was why he was getting the SCH error. You would get that as well if you try to out the ACD set when it is acquired.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.