Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Move Target lines on 7316E

Status
Not open for further replies.

mrraymond

Technical User
Sep 25, 2010
27
TH
My target lines are ringing incoming VOIP lines correctly however I would like to put the two button appearances of them to be placed above the two intercom buttons on the lower right side of the telephone instrument.

I have been thru the books and back and forth thru programming for many, many hours with no luck finding a solution.

Can target lines be moved out from their default programmed position,if so what are the steps involved.

Once again many thanks for the guidance provided by this board

Ray
 
Press Feature *81, press the button the line is on, press the button you would like it on. You can not move Intercom or Answer DN keys.
 
Hello Ray

I understand that you may have managed to program the target line onto the phone. Are they set as appear and ring?. If so then they should default to one of the top keys.

I usually use "Feature" *0 to check the keys programmed on the phone. I think you can also use "Feature" *81 (Moving Lines Lets a user move assigned lines to another button on the telephone).

Would this work?.

All the best

Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK

If it's working, then leave it alone!.
 
Thank you Gentleman for your quick response. I will give the F*81 a go. My mind was stuck in element manager as opposed to looking at possible feature codes.

Yes, the lines are set as appear and ring and do light up on the top two left keys. I do understand that they can not be moved over answer DN or intercom keys.

I will post the results of my actions.

Cheers
Ray
 
Perfect advise however it could be a very long day to move target buttons on several dozens of phones.

Am I correct that there is no way to modify target lines within the button programming in the element manager?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top