Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mouse Problem

Status
Not open for further replies.

GuyM

Technical User
Oct 28, 2001
2
GB
Anyone got ideas about this one...
Since re-installing Windows 98 SE (after another crash!), the PS/2 mouse is not behaving itself...
The Systems manager says the device is working OK and no conflicts etc. but
when I pull the mouse left, the cursor goes right and visa-versa!
Up + Down are OK its just side to side
Is thjis likely to be a Hardware fault or some mysterious setting or IRQ clash?
I've tried removing it and re-installing to no effect
Any ideas???

regards and thanks

Guy Manning
 
Dump the mouse driver and let it reinstall. That may help. Ed Fair
efair@atlnet.com

Any advice I give is my best judgement based on my interpretation of the facts you supply.

Help increase my knowledge by providing some feedback, good or bad, on any advice I have given.

 
Hi
1. I've just re-installed windows from a clean formatted drive so I don't think it will be a virus (but I will check...)

2. I have removed the PS/2 device several times and let Windows re-find and install it...to no avail!
I says 'device is working OK', but it clearly is NOT

Guy
 
Hello Guy

Judging from what you've done so far, it points (excuse the pun!) to a hardware problem. I'd try a known good mouse from another machine, or try your mouse on someone else's PC. For a basic mouse you don't need special drivers. You could try opening up the mouse to ensure it's not full of crud, hairs, etc., but sounds like the chip is up the creek.

ROGER - GØAOZ.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top