more than one CDR port on Large system

[DEEPest]

I wanted to add an RS232 port for CDR. I already have one existing CDR port on the 81C.

There are two places that you need to program to provision this:

1. LD 17 ADAN you specify USR : CTY

2. Gateopener LD 15 : CDR. Specify the port that the CDR has to go to.

I am not able to add a second port that I need the CDR to go to under "PORT"

I'm sure you should be able to add multiple CDR ports to the system.

Is it that I have to delete LD 15 entry for the existing CDR port and then specify the two ports together?

 

[DEEPest]

Think I found it. I need to say "NO" at LD 15 at the CDR prompt and then redo it by saying "YES" at the CDR prompt to specify the multiple prompts.