After power failure re-booted NT 4 Server.screen size incorrect went to change settings and screen went blank, then a message "out of frequency" "power management counts from 20 to 0 and screen goes blank. Now i dont get a logon screen. Any clues??
During NT4's boot sequence I did not get to choose between Normal or VGA mode, Have almost worn the F8 key out and rebooting to get the VGA option. Finally I got the option and was able to reset the Monitor settings. Recovery options set to zero was the problem.( now reset to 4secs) and the option for Normal/VGA is is now there when rebooting.
Thanks for the replies from yourself and Griffyn
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.