Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

MoH in between RADS on IVR

Status
Not open for further replies.

Joe King

Technical User
Feb 22, 2017
105
GB
HI
I have MiVB 10.1 and MiCC 10.1

In a Q I have a Rad playing after 10 secs then another after 30 secs, in between I get silence not embedded MoH which is what is set to play.

in all involved COS I have music on transfer set to yes

any help please.
 
In YSE, for the Queue settings, in the "Recorded Announcements" tab, what's set for "Embedded Music Source" for each RAD? Should be 0 to use the system MOH, or another selection for a different embedded MOH file. Also check the Zone ID of the Queue, but you might have to get into the MiVB ESM and look at it there in the ACD Paths form.
 
Hi Mate
thanks for replying, turns out the silence was the RADS not hanging up, so had to setup a load of COS for each RAD

Thanks
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top