Modify outgoing CLI

[Virgil]

We have a two extension ranges on a site (both registered as outgoing CLI)

79XX - 3079XX
32XX - 3012XX

We are sending/recieving 4 digits from the exchange and the 79XX range is set up OK to send the extension DDI. The 32XX range however just sends the default number for the ISDN30.

When I do a trace of and out going call I get...

time data
11:23:23 tone-receiver 01AXX03 cid 0x1cb
11:23:23 active station 3241 cid 0x1cb
11:23:23 dial 9014
11:23:23 term trunk-group 1 cid 0x1cb
11:23:23 dial 901422XXXXXX
11:23:23 route-pattern 30 preference 1 cid 0x1cb
11:23:23 seize trunk-group 1 member 17 cid 0x1cb
11:23:23 Setup digits 01422XXXXXX
11:23:23 Calling Number & Name 3241 NO-CPName
11:23:23 Proceed trunk-group 1 member 17 cid 0x1cb
11:23:23 Alert trunk-group 1 member 17 cid 0x1cb
11:23:26 idle station 3241 cid 0x1cb

I know I need to get it send the calling number as 1241 in this case, so I had a look in "change ISDN Public-Unknown-Numbering" and added a 12 prefix, but it then just sends 123241.

How do I get it to drop the 32?

Feels like I ought to know this, feeling a bit noob for not being able to figure it out, but I don't go near this bit of the system very much...

Thanks in advance for any help you can give!

 

[LambMan]

Can you send us what you have put in the station form and in the public numbering tables.

Thanks

 

[AvayaTier3]

http://www.aucommunity.com/showthread.php?t=28958

A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"

bsh

37 years Bell, AT&T, Lucent, Avaya
Tier 3 for 27 years and counting

http://bshtele.com