Mobile Extension TSE 3.2 SP3

[TeleLion]

Am trying to demo mobile extnesion, I can call the R1 number and use PBX features that works fine, my problme is when calling the remore extension, my Mobile Pbone will ring and the call is dropped after one second or one ring, if i dial the mobile number directlt 9-xxx-xxx-xxxx it works fine, am using a T-1 PRI to get in and out:

 MDSH> rocap:rou=1;
ROUTE CATEGORY DATA
ROU SEL              TRM SERV        NODG  DIST  DISL TRAF     SIG          BCAP
1   1110000001000010 5   21000300070 0     5     128  03151515 211110000031 111100

END

MDSH> rodap:rou=1;
ROUTE DATA
ROU   TYPE  VARC        VARI        VARO        FILTER
1     SL63  H'00000100  H'00000002  H'00000080  NO

END

MDSH> roddp:dest=9;
EXTERNAL DESTINATION ROUTE DATA
DEST  DRN ROU CHO CUST ADC                         TRC SRT NUMACK PRE
9         1            200520001000025110000111101 0   2   0

END

MDSH> reexp:dir=all;
REMOTE EXTENSION DATA
DIR     TYPE   DEFAULT POSITION       ACTIVE POSITION
7001    MOB    98xxxxxxxxxx           98xxxxxxxxxx

MDSH> number_conversion_print
Number conversion data:
Entry                Cnvtyp Numtyp Rou Tardest Pre                  Trc Newtyp Cont Bcap Hlc
3589                 0      0                  7001                 4
3590                 0      0                  7000                 4
1802                 1      10         9       469365
7001                 1      10         9       yyyyyyyyyy          4
xxxxxxxxxx           2      0                  98
xxxxxxxxxx           6                         7001                 10
9xxxxxxxxxx          6                         7001                 11
98xxxxxxxxxx        6                         7001                 12

TELEC3

 

[TeleLion]

Going once.


TELEC3

 

[TeleLion]

OK PELPI list was not long enough

TELEC3

 

[tanhh]

Try set D1 of ADC to 0, ie ADC=000520001000025110000111101.