Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

mm711 initializing

Status
Not open for further replies.
wpetilli

wpetilli

Technical User
May 17, 2011
1,877
0
36
US
Migrating an analog mm711 from a g700 to g450 and in multiple slots it's saying initializing. The G450 doesn't seem to be finding this module.
 
Sort by date Sort by votes
Have you done a 'nvram init' on the G450 before doing anything else? This will clean out it's RAM and memory, then restart programming. Upgrade the firmware on the G450 to latest, and make sure you load it on both Bank A and B, then login and see if the MM711 can be seen then.
 
Upvote 0 Downvote
I would check the MM HW and Software Ventage. Download the Matrix related to the version of CM that you are running. I have seen if software mismatch would cause the MM not to go to idle estate
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Houdini9881
  • Locked
  • Question
Avaya G450 Basic Module Config MM717 MM716 MM711 1
Replies
6
Views
124
NewNic
NewNic
ITHawkDriver
  • Locked
  • Question
MM710B stuck initializing
Replies
2
Views
24
ITHawkDriver
ITHawkDriver
ITHawkDriver
  • Locked
  • Question
MM711 not showing up in endpoint editor
Replies
2
Views
18
dialtonebone
dialtonebone
twlcolorado
  • Locked
  • Question
One way audio on MM711 and MM714 analog cards
Replies
7
Views
55
Sean655
S
DTDude
  • Locked
  • Question
MM711 paging
Replies
1
Views
50
dialtonebone
dialtonebone

Part and Inventory Search

Sponsor

Back
Top