LostInPhoneLand
IS-IT--Management
Hey all hope someone can help as I'm at a loss here.
I am trying to alter 2 extensions, easy enough went into WinSPM and changed the lines 20 of them, no pool data on the lines. Went into the programming for the phone extensions themselves, all went well and all 20 lines showed up. The issue is that half the lines are set to incoming and will ring back at the extensions as well as ringing front desk. I have tried to copy other extensions but the issue still persists in these two extensions alone. Instead of Line 801-N as I see on all other phones on these two I see Line 801-I.
So far nothing I have done can undo or overwrite this and I'm not sure where else to look.
When I went into Personalize Lines for the extensions I'm working with I deselected what was there and then selected lines 801 - 820. Lines in the upper range show up as expected.
Any help is greatly appreciated as if I had hair I'd be ready to pull it out.
I am trying to alter 2 extensions, easy enough went into WinSPM and changed the lines 20 of them, no pool data on the lines. Went into the programming for the phone extensions themselves, all went well and all 20 lines showed up. The issue is that half the lines are set to incoming and will ring back at the extensions as well as ringing front desk. I have tried to copy other extensions but the issue still persists in these two extensions alone. Instead of Line 801-N as I see on all other phones on these two I see Line 801-I.
So far nothing I have done can undo or overwrite this and I'm not sure where else to look.
When I went into Personalize Lines for the extensions I'm working with I deselected what was there and then selected lines 801 - 820. Lines in the upper range show up as expected.
Any help is greatly appreciated as if I had hair I'd be ready to pull it out.