Hello,
I created a MLT between 2 passport8600 (Layer2)with
6 1GB lines.
I am not sure if I must use "access" or "trunk".
What´s the difference?
And I am not sure, if I really have 6 a 6GB link now.
How can I test this?
Do I have to config STG on my trunk?
(I now have 1 STG over all ports on the passport)
Thanks a lot,
mewi
I created a MLT between 2 passport8600 (Layer2)with
6 1GB lines.
I am not sure if I must use "access" or "trunk".
What´s the difference?
And I am not sure, if I really have 6 a 6GB link now.
How can I test this?
Do I have to config STG on my trunk?
(I now have 1 STG over all ports on the passport)
Thanks a lot,
mewi