Upgraded MXEIII controller to latest release 9.0. Noticed that AMB only has 2 available ports and when I plug in 10 ASUIIs CIM1 on the mainboard goes off line. Trouble shot all the hardware and all each component works as it should until I plug in the 10th ASU. Has anyone run into this? this is my first 9.0 install so not sure if it is software related.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
MiVB release 9.0 ASU II goes off line
- Thread starter Hawaii5O
- Start date
10 x asu II via single cim card ? surely the max would be 4 ?
so do you actually have Internal CIM + 2 more Quad CIM?
have you done an upgradebootrom all after the upgrade
If I never did anything I'd never done before , I'd never do anything.....
so do you actually have Internal CIM + 2 more Quad CIM?
have you done an upgradebootrom all after the upgrade
If I never did anything I'd never done before , I'd never do anything.....
- Thread starter
- #3
Mitel just posted a document SO4236
Sites with 10 or more ASU2 units should not proceed with an upgrade to MiVB9.0
Only 9 maximum will come into service post software upgrade.
Sites will less than 9 ASU2 units will not be affected, however will not be able to add ASU2's beyond 9 units.
If I never did anything I'd never done before , I'd never do anything.....
Sites with 10 or more ASU2 units should not proceed with an upgrade to MiVB9.0
Only 9 maximum will come into service post software upgrade.
Sites will less than 9 ASU2 units will not be affected, however will not be able to add ASU2's beyond 9 units.
If I never did anything I'd never done before , I'd never do anything.....
- Thread starter
- #5
- Status
Similar threads
