Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations biv343 on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

MiVB-EX E1 outbound not working and incoming call's CLIP shows user's DDI number before answer

bojo3871

Technical User
Jul 15, 2011
67
SG
Hi all,

MiVB Software: 10.2.0.57
Controller: EX

I'm having issues with E1 on the EX-Controller.
1. Incoming call works but the CLIP while ringing shows the DDI of the user (B-number). Once connected, it updates to the correct A-number.
2. For outgoing calls, the MiNet phone immediately shows "Error". I did a TCPDUMP and could see the incoming call but not the outgoing call. ARS configuration is correct.

I'm not sure what the next thing to look at is so I am looking for some guidance. I suspect I might need to tweak the PRI settings at the EX Administration.

BR/Bojo
 
unfortunately, it is not the DPNSS access as I have that enabled in the Trunk's and user's COS. Any more ideas?
I'll try to do a syslog trace on the EX side to try and find more clues.
 
Some progress... Outgoing call now works though there are still some issues. Under Trunks > Enterprise Gateway > Gateway Configuration Script, I changed the default configuration file from whatever what was set to the Mitel Euro Standard cfg.

But I still have these:
1. While the incoming is ringing at the terminal, the caller shows the DDI number pointing to this user under Direct Inward Dialing Service. But once the call is answered or connected, the display updates to the A-number.
2. In the outgoing call, once the call is answered by the B-party, the display changes to the Trunk Label instead of the B-number.
 

Part and Inventory Search

Sponsor

Back
Top