bigabanales
Vendor
Does anyone have the programming instructions to install a wireless handset on a Mitel 5340 IP set?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations John Tel on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Mitel wireless handset
- Thread starter bigabanales
- Start date
- Status
What sort of wireless headset ?
if its the Mitel dect or bluetooth - there will be a module to attach to the back of the phone.
Install it and press the button on the module to activate it and hold down the headset button to pair
if its a 3rd party - connect its cord to the headset hole of the phone and program a headset key
if it has a lifter ( to take the handpiece off the hook) , connect it to the handset hole ( no headset button required
If I never did anything I'd never done before , I'd never do anything.....
if its the Mitel dect or bluetooth - there will be a module to attach to the back of the phone.
Install it and press the button on the module to activate it and hold down the headset button to pair
if its a 3rd party - connect its cord to the headset hole of the phone and program a headset key
if it has a lifter ( to take the handpiece off the hook) , connect it to the handset hole ( no headset button required
If I never did anything I'd never done before , I'd never do anything.....
You replace the base of the handset with the charger base, being careful to not pinch the wires as there is not a lot of room in there. Add the appliance on the back, rock it in place with the top portion touching the phone first then screw it into place. Go to your blue key menu to pair a device, press the button on top of the appliance until the stalk lights, press and hold the top of the rocker switch until it asks you if you want to pair the device...you are done st that point.
Jim
"If I had known it would turn out like this, I would have become a locksmith" Albert Einstein
NCSS NCTS NCTE CS1000E Avaya IP Office
Mitel 3300 Basic & Advanced 5000 NuPoint I&M MiCloud
Jim
"If I had known it would turn out like this, I would have become a locksmith" Albert Einstein
NCSS NCTS NCTE CS1000E Avaya IP Office
Mitel 3300 Basic & Advanced 5000 NuPoint I&M MiCloud
If its the Mitel wireless handset its pretty simple in that there is no "programming" as much as there is interaction between the set and the module. Did a wireless headset recently and basically pushed the button on the module in the back of the set then used the blue key to enter the options on the set. Once there its wireless devices or some such and you can chose to pair with the headset. You would think they would put the instructions with the set module but they don't. Go figure.
You can't duct tape stupid.
You can't duct tape stupid.
- Status