I would like to know how to configure Cisco 7941 phone to work with Mitel mxe3300. Also how to make it work with Mitel MBG " Teleworker mode " if possible
I tried the teleworker bit could not get that working. I did get it working on a 3300.
You need to provide some files (and you need to edit them) by tftp. Also you will need some firmware with it.
Do you need it? I can provide it for you.
But to be very honest you better just get some Mitel phones.
Thank you very much for your help. Yes I need these files and your help will be highly appreciated.
I do not know if i can ask you this : can I get step by step walk through ?
I don't have it anymore.
But from the top of my head, you need two files and both should have the mac address in the name of it.
These files should be in the same folder as the normal phone files on the controller.
You should also be sure that the phones get the tftp server address by dhcp.
I believe that mitel also has a document about this somewhere.
I did this years ago for local phones not teleworker and it was an absolute pain.
You need to apply the SIP FW to the phones and setup a TFTP Server for all the config files and firmware.
You can have a look at my files and see how far you get.
As tlpeter says if you can, convince them to get Mitel IP Phones.
It will save you a lot of headaches, especially with the users.
When in SIP mode they have zero features.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.