Mitel DNIC On Hold Module

[Mitelmike2010]

thread1329-1410921

Does Anyone know the minimum software requirements for a DMP Module on an SX2000?

Many Thanks In advance for your assistance.

 

[kwbMitel]

If your software will run 4000 series sets then the DMP will work.

If only 400 series sets then not sure.

*******************************************************
Occam's Razor - All things being equal, the simplest solution is the right one.

 

[Mitelmike2010]

Cheers for the Response. The System is on Q10. I remember the DMP needing Q23, but not 100% sure.

Best Regards

 

[kwbMitel]

My training/experience started at R Stream.

I feel it is unlikely that new hardware would be introduced in a Patch load but you never know.

*******************************************************
Occam's Razor - All things being equal, the simplest solution is the right one.