Mitel Dialer on MX-One 6

[dognbone]

Has anyone been able to get Mitel Dialer V2 working with an MX-One 6?

I have a client using Windows 7 with .net 4.0 installed and they are not even able to install the application. I have tried (without success) on my personal PC also running Win 7 and .net 4.0 with same result.

Then assuming that I get past that stage, would anyone know the MX-One side configuration requirements please?
I understand that CSTA is to be setup as follows:

csta -p --lim 1

Lim Port Serv IP Address

1 5062 10000010 10.16.xxx.xxx

Which I have done. Are there any other requirements/settings please?

Cheers

 

[ceejay55]

off infochannel

Yes, I used a few weeks ago Aastra/Mitel Dialer ….
Behavior was to test SIP-stack / CSTServer ( CSTA3 protocol ) …first time made in TSE6.0 …it means TR87 protocol ( ECMA323 over SIP ) …
Anyhow you need an end-user device of 67XX or 68XX SIP type, registered in TSE6.0, and your Aastra/Mitel Dialer is only a Desktopapplication
controlling
SIP-phone over TR87 protocol …..
In TSE6.0 you need a CSTA3 Setup like in my lab:
stk03001:/local/home/mxone_admin # csta -p --lim 1
Lim Port Serv IP Address
1 5062 10000010 10.16.133.20
D7 / SERV =1 means TR87 ( ECMA323 over SIP ) …and if you start Aastra/Mitel Dialer application in your PC, a monitoring point should be
automatically started on
SIP-stack ( port 5062 / CSTAServer ) …..afterwards, you can use your DA to control your SIP-phone / Aastra/Mitel Dialer …Make call, Clear Call
Answer Call & Co

 

[dognbone]

Thanks ceejay55

I had already got that far as i previously mentioned however its still not working and I still cannot get the MitelDialer.exe to install on a windows 7 PC.

Any other ideas please?

Cheers

 

[dognbone]

I should add that they use 68xx series phones.