drichter12
Technical User
Is there any way to tell remotely what speed the network ports are configured for on a 5330IP set? I am trying to determine the network AND PC port speeds.
Dale
Dale
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Westi on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Mitel 5330 network setup
- Thread starter drichter12
- Start date
- Status
Do you have access to the layer 2 switch it is connected to? Check the port setting on it. The 5330 on boot will try to auto negotiate with the layer 2 the fastest speed they both support. The e models or the attached Gig Stands, will go for 1Gig, Otherwise they will try for 100 Meg, if they can't negotiate 100 Meg, they default to 10 M. Same for full or half duplex. You can manually go into the phone and set the speed.
Otherwise I don't see anything in debug that gives you the port speed.
I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.
Otherwise I don't see anything in debug that gives you the port speed.
I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.
- Status
