Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mitel 5212 "DISP USERNAME" On LCD

Status
Not open for further replies.

MitelGuy57201

IS-IT--Management
Sep 2, 2008
19
US
I have a Mitel 5212 set that is properly programmed in the controller (I have deleted it and re-added it just to make sure) and is connected to the network. Set boots through the process fine but then sits with "disp username" on the LCD and shows up in the controller as out of service.

Any thoughts?

Thanks in advance!
 
At a guess, it is booting in SIP mode.

Stop the boot process and set the boot mode to MiNet

*******************************************************
Occam's Razor - All things being equal, the simplest solution is the right one.
 
Very possible that it may have been switched to SIP vice Minet. I will have the user unplug the phone, hold the * and 6 key down and plug it back in - that will switch it to Minet. And for switching to SIP, * and 7 while plugging it in.

Not sure if that works for all models but will for the 5212. Will post back findings.

Thanks!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top