Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mitel 3300 PRI maint command for D channel Messages? 1

Status
Not open for further replies.

300Blackout

IS-IT--Management
Jan 2, 2015
62
US
What maintenance command do I need to use to see D channel messages...Primarily messages sent out during external transfer? It is embedded T1/E1. Any Help appreciated
 
Commands change based on the type of T1 or EI or Protocol

Almost everything you need is an EDT command.

Use the helpfiles to determine the exact report you are looking for

**********************************************
What's most important is that you realise ... There is no spoon.
 
The maintenance command I use is in the EDT category as kwbMitel said.
The specific one I use for embedded T1 PRI:
EDT TRACE TSP L2L3 <enter_pri_circuit>

Once on, you will see the decoded PRI messages in relative english. Very easy to see what D channel is doing with that.
Hope that helps.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top