MITEL 3300 MXE W/RAID ARRAY

[Laylobrown]

Category Name Faulty Disk

Alarm Level Major

Total 2

Unavailable% 50

Minor Threshold 50

Major Threshold 50

Critical Threshold 100


Does this mean one of the hard drives is faulty? I believe that it does and if so the system will continue to work until it's replaced correct?

 

[paterson]

You are correct.

**************************************
Insert Witty Signature Here.

 

[kwbMitel]

It may also just mean that the mirroring is not active.

Was the mirroring enabled before?

*******************************************************
If we don't take care of the customer, Maybe they'll stop bugging us.

 

[paterson]

nice catch!

**************************************
Insert Witty Signature Here.

 

[Laylobrown]

How do you check to see if the mirroring is active? is there a command i can use? maintenance log?

 

[kwbMitel]

Check the status lights on the back.

The Tech Handbook explains all.

*******************************************************
Hard work often pays off after time, but laziness always pays off now.

 

[Opsmgr06]

Try the command Show St Redundancy it will show you if RAID is enabled or not.
Its not in any documentation either.
Try to re-raid the Disk, by re-raiding the secondary disk if that fails do a shutdown and clear the sockets of both drives and install software on the secondary and re-raid,
If that fails do a shutdown try the secondary disk with software in the primary,if that works it means the disk is ok.
If a re-raid fails replace the RAID Controller as this is the cause, from experience.