Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Mitel 3300 MXe Music on hold
- Thread starter mcarbnh1
- Start date
Program Analog Music On Hold
To program Music on Hold:
System Options form
-Set the Music On Hold option to "Yes".
(Optional) Class of Service Options form
(Optional) Set Music on Hold on Transfer to "Yes"as desired for each Class of Service.
Trunk Circuit Descriptor - E&M form
-set the Outgoing Start Type parameter to "Immediate"
-set the Transmission Facility parameter to "2 wire"
-set the 2 Wire Balanced Network Setting parameter to "600"
-set the Perform Seize Test on Out-of-Service Trunks parameter to "No"
-all other parameters may be any value.
E&M Trunks form
-Ensure that the trunk number is unique. The service number, E&M trunk circuit descriptor number, and the interconnect number may be the same as other E&M trunks.
System Acess Points form
-Set "Music Source" to "External".
In the "Music Source Port - Location ID" field, enter the PLID of the E&M trunk circuit
X-1-3-1 (where X = the Bay assigned to your Embedded Analog Main Board)
If you assigned Music on Hold to an E&M port on the AMB (on a controller with embedded analog) reboot the controller to start Music on Hold operation. Or, if you assigned Music on Hold to a port on a Universal ASU E&M card, reload the Analog Services Unit to start Music on Hold operation.
Note: Any omission of programming PLID assignment and or CIM to configured ASU will not permit Music on Hold.
**********************************************
What's most important is that you realise ... There is no spoon.
To program Music on Hold:
System Options form
-Set the Music On Hold option to "Yes".
(Optional) Class of Service Options form
(Optional) Set Music on Hold on Transfer to "Yes"as desired for each Class of Service.
Trunk Circuit Descriptor - E&M form
-set the Outgoing Start Type parameter to "Immediate"
-set the Transmission Facility parameter to "2 wire"
-set the 2 Wire Balanced Network Setting parameter to "600"
-set the Perform Seize Test on Out-of-Service Trunks parameter to "No"
-all other parameters may be any value.
E&M Trunks form
-Ensure that the trunk number is unique. The service number, E&M trunk circuit descriptor number, and the interconnect number may be the same as other E&M trunks.
System Acess Points form
-Set "Music Source" to "External".
In the "Music Source Port - Location ID" field, enter the PLID of the E&M trunk circuit
X-1-3-1 (where X = the Bay assigned to your Embedded Analog Main Board)
If you assigned Music on Hold to an E&M port on the AMB (on a controller with embedded analog) reboot the controller to start Music on Hold operation. Or, if you assigned Music on Hold to a port on a Universal ASU E&M card, reload the Analog Services Unit to start Music on Hold operation.
Note: Any omission of programming PLID assignment and or CIM to configured ASU will not permit Music on Hold.
**********************************************
What's most important is that you realise ... There is no spoon.
- Status
