Mitel 3300 icp restart

[busster]

Have just taken over maintenance on a system. Customer says that their phone system restarts every Sunday night/Monday morning. Past vendor said that this was necessary to keep the system running smoothly. I see no where to schedule an automatic system restart.

 

[paterson]

You will find this in the Maintenance Commands. If you go to this form in the ESM and then click on the "HELP" button, you will find a list and description of commands. Look under P for Programmed Reboot. There are commands to display, enable, and change this feature. If you are running any software above 6.0, then Mitel says that you do not have to reboot the controller anymore. There were issues with earlier software versions that required this command being enabled. The replacement solution for rebooting when necessary would be the Programmed Resource recovery commands. These commands will only reboot the controller if specific system thresholds are exceeded.

**************************************
I'm a big deal on the Internet. Just ask!

 

[kwbMitel]

3300 right?

maintenance commands

Programmed Reboot Schedule Display.

Weekly reboots have been unnecessary since about release 5. If it is not causing issues, I would leave it alone. However if it is causing problems, "prog reb sch off" will turn it off. you could also schedule it for monthly if you wish.

the help files are quite good.


*******************************************************
The secret to success is knowing who to blame for your failures.

 

[busster]

call accounting interface to Perle Iolan does not re-establish unless the iolan is restarted after this weekly reboot.

 

[kwbMitel]

If you have current software, turn off the weekly reboot. "prog reb sch off"

Leave the resources reboot alone.



*******************************************************
The secret to success is knowing who to blame for your failures.