When my psp RIPped my IDCS3-created PDFs, some (not all) of the apostrophes and en dashes were missing. My psp reminded me to embed my fonts.
All the fonts show as embedded under 'Properties' in the PDF version. I can't seem to accomplish this in ID, even though I've followed their help instructions: "'Subset Fonts When Percent Of Characters Used Is Less Than' Sets the threshold for embedding complete fonts based on how many of the font’s characters are used in the document. Embedding complete fonts increases file size, but if you want to make sure you completely embed all fonts, enter 0 (zero)". Although I have made this change to zero, preflight still shows I have '0' embedded fonts. I have downloaded all the updates.
An earlier thread indicated entering 100% was what was needed to embed all fonts. That just confused me more.
Please tell me how I can make preflight show I have embedded my fonts. I'm assuming this will make my apostrophes and en dashes reappear......
Thanks,
Sara
All the fonts show as embedded under 'Properties' in the PDF version. I can't seem to accomplish this in ID, even though I've followed their help instructions: "'Subset Fonts When Percent Of Characters Used Is Less Than' Sets the threshold for embedding complete fonts based on how many of the font’s characters are used in the document. Embedding complete fonts increases file size, but if you want to make sure you completely embed all fonts, enter 0 (zero)". Although I have made this change to zero, preflight still shows I have '0' embedded fonts. I have downloaded all the updates.
An earlier thread indicated entering 100% was what was needed to embed all fonts. That just confused me more.
Please tell me how I can make preflight show I have embedded my fonts. I'm assuming this will make my apostrophes and en dashes reappear......
Thanks,
Sara