MIRAN Broadcast Config in PBX?

[mspindler]

I am attempting to setup our 8 port MIRAN (3.0 software) to play a broadcast announcement on three of the ports. When I do this and attempt to playback the announcement through a Symposium script using the "GIVE RAN [route #]" I hear silence. I'm not sure if I have enough broadcast licenses on the PBX or if I configured the route and trunks correctly. However I know the MIRAN card works because the MOH is fine and I can create non-broadcast routes to playback fine through Symposium. Would anyone be able to point me in the right direction? I'll include my route and trunk config below.

Thanks in advance!

Route config:
TYPE RDB
CUST 00
DMOD
ROUT 14
DES MIRAN PORT 4
TKTP RAN
NPID_TBL_NUM 0
VTRK NO
RTYP MLVL
LGTH 60
GRD IDLE
REP 1
POST DIS
RANH
STRT DDL
WAIT RGB
BDCT YES
TITH 0
NCTH 0
ASUP YES
ACOD 5614
TARG
CDR NO
MUS NO
RACD NO
TTBL 0
OHTD NO
ALRM NO
SGRP 0
AACR NO

MIRAN TN config:
DES MIRAN_PORT_3
TN 018 0 00 03
TYPE RAN
CUST 0
XTRK EXUT
TIMP 600
BIMP 600
AUTO_BIMP NO
RTMB 14 1
CONN 0
DATE 15 MAY 2006

 

[johnpoole]

CONN 0
i don't think if connections can be left at zero. mine are 4 and above. what do you get when you dial 5614? i had trouble with that same thing when i installed the symposiumn. give ran, give ivr were dead air and a trace confirmed the connection. i just needed to boot symposium, with the pilot down, then bring up the pilot

john poole
bellsouth business
columbia,sc

 

[mspindler]

Ahh, very good find! I added that and also had to change ASUP (answer supervision) to No so that it would work. I don't understand that prompt. Would you have any idea what that does?

Thanks a lot foor finding that!