miran access code

[applepie]

how do i find what the miran access code is for opt 81c?
thx.

 

[techman3030]

What is your software rls for the miran and are you using set based or terminal based admin.

 

[applepie]

release 3, and we're using terminal based

we had avaya system, but just installed the opt 81 in march, have had no training, it's fun..

 

[techman3030]

are you wanting a password to get into the miran or are the access code to listen to the miran meassage for testing purposes?

 

[unkalary]

to access the miran card from the IO port use 'admin' as login id and 'admin000' as password. Make sure you use VT100 as terminal enulation. If you access the last port to record message the login is the same except you have to to spell it out on the keypad.

 

[applepie]

I just need to re-record one of the announcements.

 

[techman3030]

Prt the tnb of the miran port and you will see the route number that is assigned for set based access (it should be the last port on the card, it will be setup as a DID trunk). prt the route in ld 21 and get the acod for the route and this is what you dial for set based admin. use the password that unkalary gave you and you should be set.
Miran Admin is a pain, I hope this helps you out.

 

[johnpoole]

after you make the announcement and save it, go into term admin and be sure that it is associated with the channel(s)..

john poole
bellsouth business
columbia,sc

 

[applepie]

Thanks for all the help so far. Sorry, but we use set based admin for the miran. How does that change the password I use. Thanks

 

[johnpoole]

the password is flexable but the same for set and term based admin, that card is tough enough to get right from a terminal, i don't play with it from a station..

john poole
bellsouth business
columbia,sc

 

[techman3030]

John is correct as usual, Miran admin is a pain, if you have the ntp guide it is not immpossible though. If admin000 did not work as a password you might try 4321. This was the default on early rls. software.