Migrate Optipoint 500 to Optipoint STMI Card

[Nick0001]

sbcsu (TechnicalUser)15 Dec 14 09:53
Hi
REG-SBCSU:92343;
REG-SBCSU:93745;

CHA-DSSU:SIGNOFF,92343;
CHA-DSSU:SIGNOFF,93745;

CHA-DSSU:SIGNON,92343,2-1-15-4;
CHA-DSSU:SIGNON,93745,1-1-79-9;

Regards

SBCSU's directions have helped tremendously in avoiding wiring disasters. We are getting ready for a giant move, and I will be moving some phone extensions to IP phones due to lack of ports left on the regular digital cards.

Is there a method to similarly move an optipoint 500 to an optipoint 410 on an STMI4 card?

H500: AMO SBCSU STARTED

+-------------------------------------------------+
| CONFIGURATION: OPTI |
+-------------------------------------------------+
| CONNECTION: DIR |
| |
| LOCATION (PEN): 1- 2- 11- 13 |
+=================================================+
| STNO DVCFIG TSI |
+-------------------------------------------------+
| 4936 OPTIP500* 1 |
+-------------------------------------------------+
*) OPTIPOINT500

AMO-SBCSU-111 STATION AND S0-BUS CONFIGURATION OF SWITCHING UNIT
DISPLAY COMPLETED;
<dis-sbcsu:stno=4935, type=bus
DIS-SBCSU:STNO=4935,TYPE=BUS;
H500: AMO SBCSU STARTED

+-------------------------------------------------+
| CONFIGURATION: OPTI |
+-------------------------------------------------+
| CONNECTION: IP2 |
| |
| LOCATION (PEN): 1- 2- 1- 2 |
+=================================================+
| STNO DVCFIG TSI |
+-------------------------------------------------+
| 4935 OPTIIP * 1 |
+-------------------------------------------------+
*) OPTIPOINT410

AMO-SBCSU-111 STATION AND S0-BUS CONFIGURATION OF SWITCHING UNIT
DISPLAY COMPLETED;

CHA-DSSU:SIGNOFF,4935;
F27: DEVICE OF STNO 4935 IS NOT ALLOWED FOR SIGNOFF OR SIGNON

 

[Nick0001]

Bump

 

[Moriendi]

You have to delete and re-add the phone to move between TDM and IP.

 

[Nick0001]

Moriendi, thank you for the reply. If I follow the steps for a TDM phone can I apply these settings from expert mode to the IP phone?

WIll all of the commands listed below save the groups and settings if I run on a station I want to move to IP? It's very aggravating to have the HIPATH delete the extension off all of the phones that have it as a DSS or Line key.


REG-ZIEL:ALL;
REG-ACTDA;
REG-TAPRO:STN;
REG-PERSI:STN;
REG-SDAT;
REG-AUN;
REG-SA;

It appears I am going to be moving approximately 30 phones to the STMI card when the new ip phone arrive. Forgive my ignorance on this subject. Thank you.

Nick

 

[Moriendi]

Yes that looks OK. If you have any key systems you'll need KCSU for PRIM and SEC as well, but it won't let you delete if it's in a key system so it doesn't delete without warning anyway.

It is a real pain there's no easy way to do this, SXSU AMO would have been a good candidate to make this exchange easy as it will change device type between analog and digital, why they didn't amend it for IP2 devices I don't know, it seems an obvious improvement to me.