I have a referbished MICS cabinet and the newest release software of 7.1. When I power up the system it tells me "CONFIG FAILURE" Warm reset...when I recycle the power since this is my only option, I reboot it to find the same error message. Does anyone have any ideas for me or think it may be a bad cabinet, software card, etc....?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
MICS 1
- Thread starter kevpd
- Start date
-
1
- #2
Are u using a rls 2 NVRAM. This is required for 7.1 s/w. NVRAM is what the s/w card slides into.
Try the s/w in another cabinet. If problem still happens then u know it's the s/w.
Try same cabinet w/ different s/w. If problem still happens then problem is the cabinet.
Try the s/w in another cabinet. If problem still happens then u know it's the s/w.
Try same cabinet w/ different s/w. If problem still happens then problem is the cabinet.
- Status
Similar threads
- Locked
- Question
- Locked
- Question