MICS time issue stuck in central time zone?

[SR Comm]

I have a MICS 7.1 with a callpilot 100. My problem is that I can change the time either in main programming or the shortcut Feature ** TIME and in 5 minutes or so the time will change back to central time zone and I am in the eastern time zone. A MICS is not networked to get time from any other source but by manual set. Any ideas on correcting this issue I am stumped. Thank you in advance for any help or suggestions

 

[curlycord]

There is no time zone setting.
However maybe the carrier time is off, if you have CLID then turn Auto Time and Date OFF (N)

________________________________________

Add me to LinkedIN

**New Allworx Forum**

=----(((((((((()----=

http://www.curlycord.com

Toronto, CAN

 

[SR Comm]

Thanks can you tell me where Auto time and date is it in programming, is it in feature settings under system programming?

 

[curlycord]

Sounds about right, it's all in the Installer guide.

________________________________________

Add me to LinkedIN

**New Allworx Forum**

=----(((((((((()----=

http://www.curlycord.com

Toronto, CAN

 

[SR Comm]

Thanks again was called to fix this issue. Once you said auto time and date a light went off just couldn't remember where it was. I will poke around in programmimg and check that ouy. Thanks again have a great day.