MICS PRI route chngs from PRI-A to pool A on reboot

[DUCTAPE]

MICS PRI route chngs from PRI-A to pool A on reboot. MICS 4.1 w/ PRI and PRI key. It doesn't matter what route I use, when the system powers down or has a reboot I go into the route & it has changed from using PRI-A to POOL A..... WTF. I change it back to PRI-A and it works fine untill it looses power and then I have to go to the route and change it from POOL A to PRI-A. I have tried multiple diff. routes it does the same thing....

 

[curlycord]

Issue with 4.1 amd PRI
Best to upgrade to 6.1MR or 7.1
Make sure release 2 NVRAM cartridge also.


=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[DUCTAPE]

Is it an issue with all of them or just some cases?

I have another site that had t-1 for years and upgraded to PRI and now I have the exact same issue @ that site aswell....they also have carrier issue. The system gets alarms, events in Net and admin logs,and like always the Carrier says it's fine. So the sys needs a periodic reboot and when you do that you have to change route from using POOL A back to PRI A . It's a real PAIN.....

 

[dwpoole]

This issue is caused by the rls 1 NVRAM cartridge. Replace with release 2, the problem will go away.

 

[DUCTAPE]

Thanks curly & dwpoole for your responses. I'm going out there next week and will try a new NVRAM rls 2 and upgrade software. I will post the outcome to let you know. Thanks!!!!!

 

[DUCTAPE]

Sorry for the delay on this outcome.....Upgraded to 7.1 and NVRAM 2....no probs since.....THANKYOU for all your help....it is GREATLY appreciated!!!!