MICS DR 3.0 E & M snd TARGET Line Configuration

[dosjock]

I have 12 e+m lines (lines 013-024) from a T1 on a corporate lan. all lines in poolB. Sprint strips out all but the last 3 digits upon handoff the switch. I have dialtone and can place calls on any of the 12 lines. Incoming lan calls need to ring at the appropriate sets. 3 digit DN's. I expect I need to somehow map the target lines to the sets. Any help will be greatly appreciated.
Thanks

 

[jeter]

Given the E&M's are sending digits than yes target lines can be setup. Start at target line 145 (I believe) try one and then prgram the rest. “Reserve your right to think, for even to think wrongly is better than not to think at all”

Fisher CCNA,(CCNP-Routing)
UOP Student BSIT

 

[mroberts]

Target Lines Programming:
From Lines – Show
Show LN: 145 – Show (target line range from 145-275 non-XC SW, 145-336 XC SW)
Target LN – Next
Private to: (extension number) – Next
Rec’d #: (enter digits Telco is sending) – Next
If Busy: to prime – Next
PrimeSet: 221 change to the extension # - Next
CLID Set: None – Next
Aux. Ringer: N – Next
End of list

Then just assing the Target line to the phone. If it is E&M then in order for one side to dial the other side, each extention will need a target line set up for the extension. IE., Target line 145.... received digits 221.... assigned to appear and ring at extension 221. When the other side picks up, accesses the E&M trunks, dials the desired extension 221 the target line 145 will pick up on the digits 221 and ring the extension.



MRoberts

 

[mroberts]

Target Lines Programming:
From Lines – Show
Show LN: 145 – Show (target line range from 145-275 non-XC SW, 145-336 XC SW)
Target LN – Next
Private to: (extension number) – Next
Rec’d #: (enter digits Telco is sending) – Next
If Busy: to prime – Next
PrimeSet: 221 change to the extension # - Next
CLID Set: None – Next
Aux. Ringer: N – Next
End of list

Then just assign the Target line to the phone. If it is E&M then in order for one side to dial the other side, each extention will need a target line set up for the extension. IE., Target line 145.... received digits 221.... assigned to appear and ring at extension 221. When the other side picks up, accesses the E&M trunks, dials the desired extension 221 the target line 145 will pick up on the digits 221 and ring the extension.



MRoberts