I have a mics 7.1 with a pri. When I set up the target lines they show example( line 158<PVT>. When I look at the private portion of the target line, it doesn't show that it is assigned private to a ext. If I try to assign the target line to a ext. it doesn't give me the option of assigning it. The ring,ring/appr,appr only is not a option. If I program the ext. to be private in target line setup, it will then allow to to assign it to the phone, I need to assign the same target line to several phones. With it assigned as private it will only allow me to assign it to the phone that is flagged as private. All of the target line in the system has this PVT at the end of the line name. I hope someone has seen this before. Thanks in advance!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
MICS 7.1
- Thread starter 7upp
- Start date
endlesswinter
IS-IT--Management
assign target line to a hunt group, then assign the hunt group members as the extensions that need to ring
- Thread starter
- #3
endlesswinter
IS-IT--Management
there should be a change option to to make it public. When it show private:230 press change make public. Maybee your main password has been changed so you wont see all option.
curlycord
Programmer
Right
Must login with config password and not admin password.
=----(((((((((()----=
curlycord
Must login with config password and not admin password.
=----(((((((((()----=
curlycord
- Status
Similar threads
- Locked
- Question