Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

MICS 6.0 Target Line Problem

Status
Not open for further replies.

StephenComtech

Programmer
Nov 12, 2002
4
US
Recent install of MICS 6.0 with PRI. DNs changed to start from 300. Out-bound calls working fine, but on the incoming lines on the PRI, the first target line, 157 mapped to DN 300, the call comes into the system, but then it dials 55123 back out. This was diserned with a T-berd, and that's how the digits were captured. The same problem exist on DN 301, which is mapped with Target Line 158. All the other Target Lines work properly. Does anyone have any in-sight into this problem?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top