Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

MICS 4.1 added PRI but shows as 24 lines and DID landing at PRIME

Status
Not open for further replies.

helpmenow9

Technical User
Oct 23, 2009
8
US

MICS 4.1 with nvram 1.0 and flashtalk 1.9
Replacing 2 loop cards Module 2 with PRI + Combo + enabler

Now-
Dest code 9 uses route 001 to get PRI-A
Outbound working fine.

3 digits rec for all DIDs landing at prime even though Rec digits for say Line 145 map to extn 821 ring only

Maint->Port-Status->Module 2-> Card 1 shows

#Lines/loops as 24 - my other system shows this as 1

Seems as system thinks card is T1 not PRI

parameteres must be all correct since outboundworking fine with the CO ?

Any Clues please ?
 
Problem already solved by upgrading but, if above doea not help others then know there was known issues with PRI and 4.1 sometimes (rls dependant).....6.1MR (not 6.1) or better yet 7.1 should be installed to resolve these PRI issues.

Vmail requirements are 2.0 Flashtalk, 4.1 NAM or 3.0 min required for above.

=----(((((((((()----=
curlycord
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top