Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Micros Epson tm-t88v change to ethernt dip switch?

Status
Not open for further replies.

mrmicros

IS-IT--Management
Jul 5, 2006
138
CA
This is using E7

yes I know 2-8 on for the network card

Can ping from terminal to printer.

Print check it worked once. Then error pops up power failure??

If send order error pops up network communication failure?

So what should be the dip switch settings??

Serial, idn, other?

Thanks in advance.
 
Is it a T88-IV or V? For ethernet on these try:
DSW1: all off
DSW2: 8 on and all others off
 
yes. that was it. figured it out with enough messing around earlier.

Thanks for the reply.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top