2 workstations do not communicate due to dates mismatched. Cannot get it them to communicate and update the to the correct date. Workstation 2 will only download definitions but will not install or accept them. How do I fix this problem? Any help or advice is greatly appreciated. New to these machines.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Micros e7 workstations do not communicate
- Thread starter trichiemd
- Start date
michael2010
IS-IT--Management
If the error is something to the effect of "business date mismatch" try the following:
-Click through error
-Go to manager procedures and workstations
-Highlight a register
-Retrieve all defs
-Retrieve newer defs
-Do same at register but highlight the PC
-Run End of Day
-Click through error
-Go to manager procedures and workstations
-Highlight a register
-Retrieve all defs
-Retrieve newer defs
-Do same at register but highlight the PC
-Run End of Day
Go to the Network ID and make sure they are all using the same ID. As a basic rule I always use the word micros as ID.
Go to manager procedures and check the network state as wellas the active state. Network will tell you if you have connectivity. Check the IP subnet, E7 can be DHCP as it communicates by name not IP.
A workstation can only make itself active.
Go to manager procedures and check the network state as wellas the active state. Network will tell you if you have connectivity. Check the IP subnet, E7 can be DHCP as it communicates by name not IP.
A workstation can only make itself active.
- Status
Similar threads
- Locked
- Question