I bought a refab U200B Epson IDN kitchen printer and swapped out the old one to see if it worked. I tried plugging the cable to IDN1 and 2 but neither worked. So I hooked the old one back and tested fine. 5 minutes later the old one stopped working.Both printers does self test ok. I tried these on the cold remote printer side and they both worked. (Dont know why the hot and cold remotes both have the same dip switches settings).So it's not the printer or the cable.Could I have damaged something if one of the times I plugged or unplugged the IDN cable without turning the new printer off?
Also can someone recommend a repair service for Micros so I do not have to spend $300 an hour for the Micros tech to came and figure out what happened?
Any help is much appreciated.
Also can someone recommend a repair service for Micros so I do not have to spend $300 an hour for the Micros tech to came and figure out what happened?
Any help is much appreciated.