MGCP Gateway registered by PRI ports not

[noidatech]

Hi, I managed to register my cisco 2801 MGCP gateway in callmanager and but E1 PRI ports are not showing registered

when i run sh ccm in cisco 2801 it shows callmanager IP add and status as registered but on the CCM the individual PRI ports are not shwoing registed , instead they show the ip address of the voice gateway but status clearly says not registered

note my PRI ports on Router are not connected to any provider yet...should i still be able to see these ports registered in CCM

 

[pndscm]

They won't show registered until you have the PRI up and running. In MGCP mode, the D channel is backhauled all the way to CCM. Until it sees a D channel it won't show as registered.

 

[noidatech]

Thanks, This clarifies my doubt, i read about it somewhere but was not sure.

best regards