southerngent2no
IS-IT--Management
Has anyone switched from ATT to another Dialtone provider that is using a METASWITCH as their front end? We are having some issues since we cutover to the new provider. Issues are card readers not working. If we use the ATT PRI T-1 circuits they work, but if we route that traffic to the new METASWITCH PRI's they do not work. The provider has brought the new PRI's in on FIBER and broke them down to a DS-1 level for each PRI. We have 20 PRI's in this switch.
The second issue has to do with caller ID and it is very interesting. The T-1's are brought in as NI2 protocol. If we forward calls outside ourswitch they are getting too much info on the dchannel, from what we can gather so far. We can cutover traffic to the ATT T-1's and the caller ID info works fine. The ATT PRI's are the same as the other NI2. Not sure what ATT was using either 5ess or some version of it. BUT it works.. Cannot get the two providers to work together.
META is pointing back to us as our problem.
Anyone got any suggestions?? CS1000e release is 5.50J+.
The second issue has to do with caller ID and it is very interesting. The T-1's are brought in as NI2 protocol. If we forward calls outside ourswitch they are getting too much info on the dchannel, from what we can gather so far. We can cutover traffic to the ATT T-1's and the caller ID info works fine. The ATT PRI's are the same as the other NI2. Not sure what ATT was using either 5ess or some version of it. BUT it works.. Cannot get the two providers to work together.
META is pointing back to us as our problem.
Anyone got any suggestions?? CS1000e release is 5.50J+.