message SYS3011 4 0 4

[crac74]

Hi everybody. Sorry for my english (I'm French).

I can't remove a superloop (number 4) despite there's no more TN's on it. In slot 4 I used to have an ITG-P Line (2 slots). But I removed the card physically without deleting TIE created on it. I have inserted an XDLC in slot 5 and created sets.
Each time I tried to delete TIE trunks of the ITG-P card my 61C was doing an INIT (messages "can't take semaphore").
After a few INITs, backups and SYSLOAD no more TIE trunks were present on card 4.
All cards in my IPE are UNEQ.

Thanks.

 

[johnpoole]

prt
tnb
4
enter...

any tn's left?

if not disl 4
then dsxp the controller,,
ld 97
prt
xpe
return

john poole
bellsouth business
columbia,sc

 

[crac74]

No TN's left
all cards UNEQ
disable loop and disable XPE OK
but I cannot remove superloop (LD97 CHG Xsupl) because X11 (Rls 25.15) sees associated TNs. Therefore I cannot remove XPE because I must remove superloop before.
I went into pdt2 to check what was written at the configloop and XPE adresses.
I have overwritten the memory fields of superloop 4 in order to make it UNEQ (value 05) and also for the XPE (value 0).
After EDD and SYSLOAD there is no more superloop, XPE and TN's configured but the message SYS3011 refering to 4 0 4 make me think there's another place where the soft sees the card in slot 4 with superloop 4
If I create only superloop 4 and XPE, the corruption appears again : I can not remove superloop.

Any idea ?

 

[Avaya911PLM]

Go back into debug and look for a TNTRANS or DNTRANS problem on that TN. You have a pointer left in there somewhere that you need to null.

--
Fletch
Visit the Nortel Technical Support Portal at:

http://www.nortelnetworks.com/support

 

[dlesap]

Essayez cette commande :
LD 11
out
oosmlt
TN 4 x x
et ce sur chaque carte du chassis

 

[crac74]

For dlesap : command oosmlt does not work. out then cardmlt works only for cards where there's no corruption. I cannot remove card 4.

For TheFletch : I don't know what you mean by TNTRANS or DNTRANS ? which command I can use to print them ?

Thanks.