I configured my APC to send a trap every time power is lost. TNG is then paging me with this information. The problem is I get two pages in row saying power was lost and then power was restored. Does anyone know how to get TNG to trap the message and hold it for 1 minute. If power is restored then page me? I know how to trap the message and delay but I don't know how to check the condition.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Message actions? 1
- Thread starter krock103
- Start date
-
1
- #2
Hello krock103,
Try the following:
------------------
Step 1: Create two msgrecs, one for PowerDn and one for PowerUp trap.
Step 2: For PowerDn msgrec, add the following actions to it:
10) setenv APC=0
20) delay 60
30) Use getenv or tstenv to check the value of APC
40) If APC=1, then page, else exit
Step 3: For PowerUp msgrec, add the following actions to it:
10) setenv APC=1
Thanks,
Gyan
Try the following:
------------------
Step 1: Create two msgrecs, one for PowerDn and one for PowerUp trap.
Step 2: For PowerDn msgrec, add the following actions to it:
10) setenv APC=0
20) delay 60
30) Use getenv or tstenv to check the value of APC
40) If APC=1, then page, else exit
Step 3: For PowerUp msgrec, add the following actions to it:
10) setenv APC=1
Thanks,
Gyan
- Status
Similar threads
