Merlin to IPOffice

[dfed]

Trying to network a Magix to IP Office using a "home-made" point-to-point pri, i.e., the Magix shold be grabbing dialtome from the IP Office.
Currently I can make calls fron the IP Office to the Magix, but not from Magix to IPOffice... I also can't make the Magix grab dialtone off the IPOffice's dialtone.

I'm thinking about flattening the Magix and starting from scratch.
I've looked at Tech Tip #134, but there doesn't seem to be enough information there... it's only a couple pages in length.

Does anyone know of a document that walks a programmer through setting up a PTP from Magix to IPOffice?
--- OR ---
Does anyone have configs or Magix print reports they'd care to share?

Thanks in advance.

 

[SYQUEST]

Try the Legend Network Reference Guide document, which is downloadable for free from support.avaya.com. Second, you might search through the IP Office forum, I believe someone has posted such a request not too long ago. It is a busy forum, so you may have to wade through a lot. Some of the networking has been posted in this form also, so search away!

....JIM....

 

[dfed]

Thanks for the response.
Would a standard patch cable work between the two switches or would I need a cross-over? Assuming I'm going directly from the IPO to Legend?

 

[kwing112000]

Usually you would need a t1 crossover to go between 2 CPE units. It is 1,2 and 4,5 that are crossed.

1>>>4
2>>>5

Kevin Wing
ACSS Small and Medium Enterprise (SME) Communications
ACS- Implement IP Office
ACA- Implement IP Office
Carousel Industries

 

[memphisribs]

Recently setup Merlin to IP Office network, tech tip #134 was all that was needed. When conecting a DS-1 module directly to a DS-1 module a T-1 crossover cable is normally required. When connecting to a smart-jack or equivalent, a straight cable normally works. I was suprised that I got CID number but not name dialing from either end. There may be something else I missed.
Good Luck

46 years in the business and counting.