Merlin PRI

[oge]

I recently installed a 100 DCD on a magix 2.1. The layout of the system is a follows; processor,412 tdl, 800 gs/ls, 016 ETR, 800 GS/LS 016 ETR, Merlin Messaging and the 100 DCD card. I just found out that ever since the card was installed the system has been rebooting every hour os so on its own. The transient error logs are as follows; software cold start code0003, DS1 misframe code 6c09, Invalid sanity response code7804, command buffer full code000E, power up warm start code0002, power up cold start code0016. I checked the 100 DCD card and it is not a 517M. I dont know if it a bad card or what. I am going to pull it any way and see if it still happens. Any ideas.

 

[oge]

Sorry for the error, the card is a 100 DS1 card

 

[merlinman]

Can you remove the 100-DCD and see what the system does?

The 100 DCD has no issues (like the previous 100-D mods) with 016 Mods, as I have been told by some folks in the know.

So now, we are in the ISOLATE and TEST mode.....