Can some one please help me with regards to talking directly to an old Meridian Link Card (A0669468). I need to check the ip address etc and don't know any inputs?
The only way i know is :
- Log in with maint access
- type stopNSE
- type startNSE and system will prompt you for changing parameters. You will see the actuals
- To change Gateway and mask, type install in maint access
I am afraid that has not helped! When I connect to port 1 I get a '#' and most things I type come back with a 'ksh:'?????
Here is an example:
# logi maint
ksh: logi: not found
# maint
ksh: maint: not found
# mani
ksh: mani: not found
# maintenance
ksh: maintenance: not found
# start nse
ksh: start: not found
***
# Maint
ksh: Maint: not found
# MAINT
ksh: MAINT: not found
# maint
ksh: maint: not found
# exit
ENTER RUN LEVEL (0-6,s or S): S
will change to state S
INIT: SINGLE USER MODE
/local/bin/TermSetup[37]: tput: not found
/local/bin/TermSetup[45]: tput: not found
/local/bin/TermSetup[51]: tput: not found
/local/bin/TermSetup[67]: tput: not found
/local/bin/TermSetup[72]: tput: not found
***
erase = ^h kill = ^u intr = ^c quit = ^|
***
# MAINT
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.