Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Meridian 61c backup trouble

Status
Not open for further replies.

twin60

Programmer
Jul 22, 2009
36
US
Hello
I am having trouble doing a manual backup in LD 43. When I type EDD I get a 0008 message, which means BACKUP DISABLED. I cannot find out how to reenable the backup.
Thanks for your help
 
Try doing this. Log in to the switch but don't go into any load. Then type in the command enlt. See if that fixes it.
 
yes I have 2 cpus and both show ENBL
 
I tried the enlt, but that did not work. I think it just doesn't like me
 
EDD008
Storage device disabled.
ACTION: For MSI - Use ENL MSI x in LD 37 to enable the storage
device. If the MSI does not enable and the fault does not clear, replace
the MSI card(s) following the steps in the Hardware replacement
guide. Verify that the fault is cleared. If you need help with the
commands or system responses refer to the IOD chapter in this guide.
For CMDU use DIS CMDU n and DIS IOP to disable both CMDUs
and IOPs. Use ENL CMDU n and ENL IOP to re-enable the active
CMDU and IOP. Try to data dump again. If you are successful, use
the SYNC command to synchronize the CMDUs. If you need help
with the commands or system responses refer to the CIOD chapter
in this guide. If you are not successful, contact your technical
support group.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top