LDthirtytwo
Technical User
Where can I find what the flashing LED's mean on my DECT AP2000S Acccess Points?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Meaning of the flashing LED's on AP2000s Dect Access Points
- Thread starter LDthirtytwo
- Start date
- Status
soaressteevan
Technical User
Follow This :-
DAP LED Indications
The DAP is equipped with one LED. The LED can indicate 6 different statuses of the DAP.
The following indications may occur.
Visibility Checking
After the installation is finished and the DAPs are up-and running, you must do visibility check
The visibility check is necessary, to determine if the DAPs can “see” each other.
Use the following procedure to execute the visibility check.
PROCEDURE:Checking the Visibility
Start the Performance Manager in an Internet Explorer window. To do this, enter
the following URL: The following window should be visible:
LED Status Meaning
1.Off = No power.
2.0,5 seconds On or 0,5 seconds Off = Loading software/firmware.
3.Short flash every 0,25 seconds = IP Network error (not connected, no DHCP/TFTP server, no DAP Controller)
4.Fast blink = DAP operational, but trying to synchronize to another DAP.
5.Continuous fast = blink Hardware error.
6.Steady On = DAP operational (and synchronized to other DAP or is the synchronized master)
DAP LED Indications
The DAP is equipped with one LED. The LED can indicate 6 different statuses of the DAP.
The following indications may occur.
Visibility Checking
After the installation is finished and the DAPs are up-and running, you must do visibility check
The visibility check is necessary, to determine if the DAPs can “see” each other.
Use the following procedure to execute the visibility check.
PROCEDURE:Checking the Visibility
Start the Performance Manager in an Internet Explorer window. To do this, enter
the following URL: The following window should be visible:
LED Status Meaning
1.Off = No power.
2.0,5 seconds On or 0,5 seconds Off = Loading software/firmware.
3.Short flash every 0,25 seconds = IP Network error (not connected, no DHCP/TFTP server, no DAP Controller)
4.Fast blink = DAP operational, but trying to synchronize to another DAP.
5.Continuous fast = blink Hardware error.
6.Steady On = DAP operational (and synchronized to other DAP or is the synchronized master)
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Solved