MD110 & SIEMENS GIGASET UNKNOWN IPEI 2

[BeoLink]

Hi,
We have a MD110 and an integrated dect solution with Ericsson DT368 & 570. We also have some Siemens Gigaset 4010/4015 handsets that we wish to use on the same basestations.

When trying to program these in the Extensionmanager, we
ran into the problem that the IPEI number isn´t noted anywhere on or in the phone (siemens denied there is a command to show the phones IPEI). I´ve been told it is possible to get this to work, but I have no clue whatsoever how to get the IPEI numbers from the siemens phones or how to solve it in any other way!!!

Please help!

/Andy

 

[toksmurfen]

First off, thanks for this information it really helped me out!
But when I try to register more than 1 Siemens phone in our MD110, I can't don it.
I have to switch to another base before I can register the second phone, is there a workaround for this?
We have about 60 DT368 and DT570, but we would like to phase them out with Siemens because of the high cost of repairs for the DT phones.

//Daniel

 

[toksmurfen]

I've just noticed something else, missed calls aren't working.
Caller ID is working but the numbers that I've missed don't get saved in the missed calls.
Is there something in the MD or in the phone that I can change so that it will work?

 

[SLU]

I have done some tests with Siemens Gigaset 4010 micro in both integrated DECT and in DCT1800 GAP.

The gigaset 4010 micro only has the GAP protocol so you will only have problems if you connect it to MD110.

But in DCT1800 GAP it will work with some limitations.

1. The clock is reseted if you turn of the phone, because the time is stored in siemens basestation.

2. Missed calls doesn't work because the list is stored in the basestation and not in the phone.

3. If you have programmed the phonebook with an internal extensionnumber ( e.g. nr=8130 name=Stefan) and you receive an external phoncall ( 184408130 )where the four last digit match, the Caller id will show "Stefan" calls.

4. You don't get message waiting indication on the phone.
(no indication in the display).

If you are going to use Siemens gigaset phones in DCT1800 GAP you need to disable the crypt. You disable it with Cordless system manager in menu System/Configuration click on advanced button then in system tab you have a checkbox with encryptation enabled. You need to change accesslevel to distributor.
If you don't disable the crypt you will have a dropt call 10 seconds after a handover between 2 basestations.

 

[Carollo]

I have a problem with Siemens Gigaset SL1 working under MD110 BC 12 Integrated DECT system. The portable works fine within BS connected to same ELU32 board but it does not work under BS connected to another ELU32 board even if it is in the same LIM.

Can anyone help me configure either Gigaset or MD110 to enable this hand over ?

Thanks in advance.

 

[dermetz]

Dear All,

I have a DCT-1800 GAP cordless solution with analog interface and currently I am thinking in migrating to a digital solution. Also we are using a Siemens Hicom 300 PBX. Do I have to purchase MD110 and also SLMD cards for the PBX