MCIS 4.0. PRI. Adding new DID

[parm2013]

Somewhat familiar with the programming


DIDs set up to 170 some above. 16 extensions with direct dial.

Adding a DID at line 171. Line type is Public...changed to 2222 which is the extension where I want it to ring. Rec'd is none...I want it to be 2222. I put in 222 and it will one take the last 2. Remains none. If busy to prime. Prime set 2222. Everything is fine but the Rec'd which is set to none

Any idea why that's is happening ? The extension is otherwise working fine

 

[parm2013]

Got it working partially

I was mistakenly putting in the extension for the rec'd.

Put in the last 4 digits of the DID and it took it.

I use an outside line on the same phone system and it rings through to the extension it's set for, but when I call the line from my cell it's not in service

 

[parm2013]

Getting a 6UT2 not in service from my cell phone

 

[hawks]

That sounds like a telco issue