Is it possible to turn on and off the mwi with the mci via the mp card? I am having trouble getting it to work. Any tips? I am using RS1, 9600, No parity check 7 data bits, 2 stop bits.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
MCI on MP
- Thread starter ctvi
- Start date
LDthirtytwo
Technical User
Yes it is, I would move the MCI to port 0 and follow the MCI programming in the feature programming manual. 9600-8-N-1 is the normal set up for MCI. If you use this set up port 1 is now available for Mat/Modem depending on how SW 4 on the CPU is set. Use the correct cable of the MCI will not work.
Is the MCI working at all? If it is, but you are just wanting to use it for lights you need to change the message on/off codes in the VM. If you are working with an AD-40, AD-64, or and IM-16 you need to go to the switch setup screens and change from the lamp on off codes to I believe to "@,X" or just "@" (I can't remember off the top of my head).
- Thread starter
- #4
I have centralized voicemail with remote telephony servers from Callware. The Centralized system can turn off and on via ccis the lights. But the local telephony server can not!! I downloaded the mci tool and even that cannot turn it on or off. There must be something else that is up.
- Status
Similar threads